Bien-Air Dental CHIROPRO 3rd Gen Instrucciones De Uso página 17

1
• Turn the knob CW or CCW to respectively increase or
decrease the micromotor maximum reachable torque (quick
setting mode).

The torquemeter (3) turns cyan and displays the set
micromotor maximum reachable torque.
Note 11
• Long press on the knob to change operation settings.
See chapter "8 Settings" on page 16 for details.
• Long press on the orange button to activate the 5 Ncm
torque boost.
Note 9
C. Short press on the footpedal's orange button or on the knob to go
to the next step.

The next step symbol turns green and the step's last used
settings are restored.
Note 7 - 10
FIG. 3
1 2
FIG. 4
NOTES
1
Real-time speed value is displayed in black when the MX-i
rd
LED 3 Gen micromotor is running. Maximum reachable speed
value stored is displayed in cyan when the MX-i LED 3
cromotor is not running, in steps P1 and P2.
2
Torquemeter is only displayed when micromotor speed is be-
low 100 RPM in steps P1 and P2.
3 The contra-angle ratio is cyan-colored for direct-drive and
green-colored for reduction gears.
4
Torque bar graph is only displayed when micromotor speed is
below 100 RPM.
5
Each step settings are restored from the corresponding step
last used settings, excluding quick settings made directly in the
Operation mode.
6
In REVERSE mode, the rotation direction symbol
and there is a sound alert (alternate medium beeps). The Torque
value is automatically increased in REVERSE mode when torque-
meter is displayed. The torque value can be increased from 0 to
10 Ncm, see chapter see " Reverse torque boost value" on page 18
to adjust it.
7
Actions on footpedal's buttons have no effect when the micro-
motor is running.
8
Changing the torque in steps P1 or P2 can only be performed
through the Settings mode.
9
The torque boost can only be activated when the torquemeter
is displayed in Operation mode, in low speed steps (<100 RPM).
10
For safety reasons, the speed setting icon turns red and
blinks together with the speedometer for 2 seconds when switch-
ing from low speed to high speed (≥100 RPM) step.
11
Changing the speed in steps P3, P4 and P5 can only be per-
formed through the settings mode.
3 4
5
rd
Gen mi-
blinks
15