Trimmer Operating Safety - Maruyama B230C Manual Del Propietário

10 ft. (3 m) minimum
8. Allow the engine to cool before refueling.
9. Drain the tank and run the engine dry before
storing the unit.
10. Store fuel and Trimmer away from open flame,
sparks and excessive heat. Make sure fuel vapors
cannot reach sparks or open flames from water
heaters, furnaces, electric motors, etc.

Trimmer Operating Safety

1. THIS TRIMMER CAN CAUSE SERIOUS
INJURIES. Read the instructions carefully. Be
familiar with all controls and the proper use of the
Trimmer.
2. Make sure the 3 mm hex wrench has been removed
from the bearing case and boss adapter before you
start the engine.
3. Avoid using the Trimmer near rocks, gravel, stones
and similar material which can become dangerous
projectiles.
4. Inspect your work area before you begin. Remove
objects such as broken glass, nails, wire and rocks
which can become dangerous projectiles if thrown
by the Trimmer. Remove string, rope or similar
materials which can become entangled in the
cutting head.
5. Keep children, bystanders and animals outside a
50 ft. (15 m) radius from the operator and
Trimmer.
50 ft. (15 m minimum)
6. If you are approached while operating the
Trimmer, stop the engine and cutting head
rotation.
7. Never allow children to operate the Trimmer.
8. Use the Trimmer only in daylight or good
artificial light.
9. Never operate the Trimmer without proper guards
or other protective safety devices in place.
10. Always keep the Trimmer on the right side of
your body.
11. Do not raise the cutting head above waist level.
12. Do not put hands or feet near or under any rotating
parts. Keep clear at all times. Keep all parts of
your body away from the rotating cutting
attachment and hot surfaces such as the muffler.
13. Keep firm footing and balance. Do not overreach.
14. Use the right tool for the job. Do not use the
Trimmer for any job that is not recommended by
MARUYAMA.
— US-8 —