Connecting Throttle Cable; Installing Debris Shield - Maruyama B230C Manual Del Propietário

Connecting Throttle Cable

1. Loosen the knob and remove the air filter cover, insert
the throttle cable through the cable adjuster sleeve on
the carburetor bracket. Make sure the end of the cable
housing is seated positively in the sleeve.
Cable Adjuster Sleeve
Throttle Cable Housing
Carburetor
Bracket
Cable Adjuster
Sleeve
Carburetor Throttle Cam
Slotted Fitting
2. Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
3. Rotate the carburetor throttle cam clockwise and slip
the throttle cable through the slot in the slotted fitting,
making sure the cable lug drops into the recessed hole.
4. Operate the throttle trigger a few times to make sure
that it works correctly.
5. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle stop
when the throttle trigger is fully depressed.
6. When the throttle cable is adjusted correctly, tighten
the locknut.
7. Reinstall the air filter cover and tighten the knob.
Locknut
Throttle Cable
Slotted Fitting
Recessed Hole
Cable Lug
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Idle Speed Adjustment Screw

Installing Debris Shield

POTENTIAL HAZARD
• Foreign objects can be thrown by the
String Trimmer.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the String Trimmer with-
out the debris shield in place.
POTENTIAL HAZARD
• The cutoff blade is sharp.
WHAT CAN HAPPEN
• Contact with cutoff blade could cause
serious cuts or personal injury.
HOW TO AVOID THE HAZARD
• Keep hands, feet and clothing away
from cutoff blade.
1. Fasten the string cutoff blade to the debris shield
with two M5 x 16 screws, hex nuts and lock
washers as shown.
2. Push the debris shield onto the bearing case.
Install the M6 x 40 screw and nut.
Tighten ONLY AS NEEDED.
M6 x 40 Screw
Bearing Case
Hex Nut
— US-11 —
WARNING
CAUTION
M5 x 16 Screw (2)
Debris Shield
String Cutoff Blade
Lock Washer (2)
Hex Nut (2)