Intended Use; Improper Use; Safety Signs; Identification Label - Stiga PR 500 Li 48 Manual De Instrucciones

and can use the main controls, always remaining
at a safe distance from the cutting means.

3.1.1 Intended use

This special type of chainsaw
has been designed specifically for the
trimming of trees and must only be used
by a trained operator following carefully
planned and secure work instructions.
This chainsaw is only destined to the
trimming of trees when the above-
mentioned conditions are complied with.
It is generally conceived for use with two
hands, just like a standard chainsaw.
Some national regulations can
restrict use of the machine.
This machine was designed
and manufactured for:
– trimming and cutting of tall tree tops;
– cutting hedges, trunks or wooden
beams, the diameter of which depends
on the length of the guide bar;
– cutting wood only;
– use by one operator only;
– use by qualified operators who have received
specific training on tree maintenance.

3.1.2 Improper use

Any other usage not in keeping with the above-
mentioned ones may be hazardous and harm
persons and/or damage things. Examples of
improper use may include, but are not limited to:
– trimming hedges;
– carving operations;
– sectioning pallets, crates and
various packing materials;
– sectioning furniture or other materials with
nails, screws or other metal components;
– butchering meat;
– using the machine to cut materials other than
wood (plastic materials, building materials);
– using the machine to lift,
move or split objects;
– using the machine while
fastened to fixed supports;
– using cutting means other than those
found in the "Technical Data" table;
Serious injury and wound hazard;
– use of the machine by more than one person.
IMPORTANT Improper use of the machine
will invalidate the warranty, relieve the
Manufacturer from all liability, and the user
will consequently be liable for all and any
damage or injury to himself or others.
3.1.3 User types
This machine is intended for use only by
operators trained in tree maintenance.

3.2 SAFETY SIGNS

The machine has various symbols on it
(fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
Warning! Read the instructions
before operating the machine.
Warning! The failure to use
this machine correctly can be
hazardous for oneself and others.
Danger! Wear ear protectors, safety
goggles and a protective helmet.
Wear gloves and non-
skid safety boots!
Danger! Do not leave the machine
in the rain or in damp conditions.
Beware of kickback! Kickback
is the rapid and uncontrollable
backward motion of the chainsaw in
the direction of the operator. Always
work in complete safety. Use chains
with safety links that limit kickback.
Warning! Never hold the
machine with one hand! Hold
the machine firmly with both
hands to control the machine and
reduce the risk of kickback.
Danger! Wear protective clothing.
This chainsaw is only suitable for
use by operators who have received
training on tree maintenance
(see instruction manual).
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.

3.3 IDENTIFICATION LABEL

The identification label holds
the following data (fig. 1):
EN - 6