Heart Rate Data When Using Chrono Mode; Chronograph Display Format; Chrono Mode Notes & Tips - Timex Ironman Triathlon Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 232
7. Press START/SPLIT to continue timing OR press and hold
STOP/RESET/SET to clear the chronograph display and set it back to
zero. This also saves chrono data in the watch database.
NOTE: If all workouts are locked you will see the message WORKOUTS
LOCKED - UNLOCK IN REVIEW. In this instance, the watch cannot save
any data for a workout.

Heart Rate Data When Using Chrono Mode

When you operate the watch in Chrono Mode with the Heart Rate Sensor,
you will accumulate heart rate related data in Review Mode, including:
1. Amount of time your heart rate stays within your target heart rate zone
(shown as IN ZONE in Review Mode);
2. The average heart rate for the complete time the Heart Rate Sensor
was operating and the chronograph was running (shown as AVERAGE
in Review Mode);
3. The average heart rate for each recorded lap (shown as LAP DATA in
Review Mode); and
4. Peak and minimum heart rates for the complete time the Heart Rate
Sensor was operating and the chronograph was running (shown as
PEAK and MINIMUM in Review Mode)
20

Chronograph Display Format

You can set the Chronograph to show either the lap or split time on the
lower display line.
1. Stop and reset the Chronograph.
2. Press and release the STOP/RESET/SET button. You will see FORMAT
on the display, followed by SET, and then the current format setting.
3. Press START/SPLIT (+) to select the format you would like.
4. Press STOP/RESET/SET (DONE) to save your setting and return to the
Chrono.
Note that although the format setting implies that Chrono time values are
shown in both the upper and lower display lines, when using the Chrono
without the heart rate sensor, the upper display line is reserved for the lap
number, so only the lower line of timing information is shown. However,
when using the Chrono with the heart rate sensor, it is possible to see
both lap and split timing information at the same time if desired.
Chrono Mode Notes & Tips
Press MODE to switch to Time of Day Mode while running the
chronograph. The stopwatch icon (
chronograph is still operating.
When the chronograph is running along with the Heart Rate Sensor you
W
) will appear to indicate the
21

Publicidad

Tabla de contenido
loading

Tabla de contenido