Functions; Operation - Amann Girrbach Ceramill Therm 3 Manual Del Usuario

6.3

Functions

Handling
▷ To select a function: Press the
respective number key.
▪ Key 4: Function "Preset time for program"
Programming
To program function 4:
▷ Press the
key.
▷ Press the
key.
▷ Using the number keys, enter the desired time
[hh:mm] until the program starts. The time is
rounded exactly to 10 minutes.
After entering the last digit, the cursor will
jump back to the first numerical location,
so that possibly required corrections can
still be made.
▷ Press the
key.
▷ Press the
key.
▷ In the list, select the desired program with the
keys
-or-
▷ directly select the program by pressing the
key and the respective number key.
▷ Press the
key.
The program is taken over with the time preset.
The display switches to the operating level.
After the program starts, the preset time runs
off first, then the program starts.
A P P L I C A T I O N A N D O P E R A T I O N
6.4
key and the
Damage to the heating rods!
▷ When loading and unloading the furnace, do
not bump against or come in contact with the
heating rods!
Loading the Ceramill Therm 3 with zirconium
oxide frames in a sintering bowl is described in:
_ The Ceramill system training documents
_ The operating instructions of the Ceramill zirco-
nium oxide blanks
▷ Load the furnace with the units.
▷ Shut the furnace door.
▷ Switch the furnace on with the mains switch.
▷ Select the sintering program (see page 39).
▷ Define the sintering program, if required (see
page 40).
▷ Start the sintering program with the
After the program has elapsed, the heating
cycle automatically switches off.
Danger of burning!
▷ To remove the sintering bowl, use the sinter-
ing-bowl prongs or other suitable pliers.

Operation

NOTE:
WARNING:
E N
key.
41