Pratissoli MK Serie Manual De Reparación página 52

Apply tab 22x14x100 in the shaft housing (pos. , Fig. 62) and
insert the ring gear on the shaft.
Fasten the ring gear stop (pos. , Fig. 63) using the 2 M10x25
screws (pos. , Fig. 63).
Calibrate the screws with a torque wrench as indicated in
chapter 3.
Apply the 3 Ø12x40 pins on the reduction gear box (pos. ,
Fig. 64) and insert the gasket (pos. , Fig. 65).
Fig. 61
Mount the bearing on the reduction gear cover (pos. ,
Fig. 66).
Fig. 62
Fig. 63
52
Fig. 64
Fig. 65
Fig. 66