Power Ratings; Parts And Accessories - Simplicity SZT350 Manual Del Operador

PROBLEM LOOK FOR
Mower cut is uneven. Mower not leveled
properly.
Rider tires not inflated
equally or properly.
Mower cut is rough Engine speed too slow. Set engine speed
looking.
Ground speed too fast. Decrease ground
Engine stalls easily with Engine speed too slow. Set engine speed
mower engaged.
Ground speed too fast. Decrease ground
Cutting height set too
low.
Discharge chute
jamming with cut grass.
Excessive mower Blade mounting
vibration. hardware is loose.
For all other issues, see authorized dealer.
Specifications
ENGINE
Briggs & Stratton
Intek™ Series

Power Ratings

The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995. Torque
values are derived at 2600 RPM for those engines with "rpm" called out on the label and 3060 RPM for all others; horsepower
values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power
values are taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments.
Actual gross engine power will be higher than net engine power and is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Given the wide array of products on which engines are placed, the gasoline engine
may not develop the rated gross power when used in a given piece of power equipment. This difference is due to a variety
of factors including, but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carburetor,
fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine
variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for
this engine.
Note: The engine information contained in this manual applies
to Briggs & Stratton engines only. For information regarding
non-Briggs engines, refer to the engine manual supplied with
your unit.

Parts And Accessories

See an Authorized Service Dealer.
20
REMEDY
Displacement
Professional Series™
See Mower Deck
Leveling .
Displacement
See Maintenance section.
All Engines
Oil Capacity
Spark Plug Gap
control to FAST.
Spark Plug Torque
speed.
CHASSIS
control to FAST.
Fuel Tank Capacity
Inflation Pressure
speed.
- Front Wheels
Cut tall grass at
- Rear Wheels
maximum cutting height
during first pass.
TRANSMISSION
Cut grass with
discharge pointing
Type
toward previously cut
area.
MOWER
Tighten to 50-60 ft-lbs
(68-81 Nm).
Width of Cut
Cutting Height
44.18 cu in. (724 cc)
44.18 cu in. (724 cc)
64 oz (1,9 L)
0.030 in. (0,76 mm)
180 in-lbs (20 Nm)
3 gal (11,4 L)
22 psi (1,52 bar)
12 psi (0,83 bar)
Hydro-Gear® EZT®
Hydro-Gear® ZT-2800®
42" (107 cm)
44" (112 cm)
46" (117 cm)
48" (122 cm)
52" (132 cm)
1.5" - 3.75" (3,8 - 9,5 cm)
1.5" - 4.5" (3,8 - 11,7 cm)