Tabla de contenido
Publicidad
4
MAINTENANCE
4.3
ENGINE OIL ______________________________________________________________
Check the engine oil at the start of each day, before starting
the engi ne. If the oil lev el is low, r emove oil fil ler c ap, and
add oil as required.
Perform initial oil change after first 50 hours of operation and
every 100 hours thereafter. See Engine Manual.
Use only engine oils with API classification CD/CE.
Above 77°F (25°C)
32 to 77°F (0 to 25°C) SAE 20W or SAE 10W30/10W40
Below 32° (0°C)
4.4
AIR FILTER_______________________________________________________________
Check the service indicator daily. If red band appears in the
window (C) replace the element.
Do not remove the element for inspection or cleaning.
Unnecessary remov al of the fi lter i ncreases the ri sk of
injecting dust and other impurities into the engine.
When service is required, first clean the outside of the filter
housing; then remove the old element as gently as possible
and discard.
1.
Carefully c lean the i nside of the fil ter hous ing without
allowing dust into the air intake.
2.
Inspect the new el
element and never use an incorrect element.
3.
Assemble the new el ement and mak e s ure it s eats
properly. Reset the indicator by depressing button (D).
4.
Reassemble c ap mak ing s ure i t s eals c ompletely
around the fi lter hous ing. Dus t ev acuator (E) m ust b e
facing down.
5.
Check all hoses and air ducts. Tighten hose clamps.
20
SAE 30W or SAE10W30/10W40
SAE10W or SAE 10W30/10W40
ement. Do not us
e a damaged
Safe Operating Range
E
Figure 4A
D
C
Figure 4B
Publicidad
Tabla de contenido
