Ottobock C-Leg Serie Información Para El Usuario página 31

The standing mode is an additional functional feature of the 1st mode. It makes it easier for you to stand on an
inclined surface for a longer time. The C-Leg is fixed in the flexion direction at a flexion angle between 7° and 70°.
For individual use of the standing mode function, please proceed as follows:
Turning the standing mode function on
Requirement: The knee joint is fully bent.
Activation of the remote control:
Press key 3 and keep it pressed (Fig. 1) until the joint confirms the activation with
a vibration signal.
1
Turning the standing mode function on:
Within 3 seconds after activation of the remote control simultaneously press the
keys 1 and 2 (Fig. 2) until the joint confirms turning on of the standing mode with
three short beep signals.
2
Using the standing mode
Adjusting the standing angle
0°
7°
70°
0°
7°
70°
2
INFORMATION
Slow extension (Fig. 2): Actively standing up from sitting at this speed would take about 2 – 5 seconds.
C‑Leg
1 Flex the joint between 7 – 70° and keep it still for one second (Fig. 1).
2 Slowly extend the joint up to the desired angle (70 – 7°; Fig. 2).
3 In this position, keep the joint still for one second until the C-Leg shortly
vibrates.
4 The blocked joint can now be fully loaded in the flexion direction.
1
Ottobock | 31