Generac G0060980 Manual Del Propietário página 34

Maintenance
Press MANUAL on the control pad to start the engine. A blue LED illuminates to confirm that the system is in the
12.
MANUAL mode.
Allow the engine to run for a few minutes. Check for leaks while the engine is running.
13.
Press OFF on the control pad to shut the engine down. A red LED illuminates to confirm that the system is in the
14.
OFF mode.
Remove dipstick and wipe with a clean cloth.
15.
Completely insert the dipstick and then remove it.
16.
Verify that the oil level is at or near the FULL mark.
17.
If necessary, remove the oil fill cap and slowly add oil until the level is at the FULL mark.
18.
DO NOT OVERFILL.
Install dipstick and oil fill cap.
19.
NOTE: Dispose of used engine oil and oil filter at a proper collection center.
A
28
Figure 4-3. Oil Drain and Filter Location
Synergy Automatic Standby Generator Owner's Manual
B