User Programmable; Exercise Time; Usb Port For Firmware Updates - Generac G0060980 Manual Del Propietário

Operation
3.5.2— User Programmable
3.5.2.1—Exercise Time
A programmable exercise time is provided. In the AUTO mode, the engine starts and runs at the programmed interval,
either weekly, bi-weekly (the default), or monthly, at the time and day specified. During the exercise cycle, the unit runs
approximately five minutes and then shuts down. Transfer of loads to the generator does not occur unless utility power
fails. For more information, see Subsection 3.12 —Setting the Exercise Timer.
3.6 — USB Port for Firmware Updates
A USB port is located beneath the rubber flap adjacent to the control pad, and is provided for firmware updates. Firm-
ware updates must be performed by an Independent Authorized Service Dealer.
NOTE: The USB port is intended for use with a USB thumb drive only. The USB port is not intended for
charging devices such as phones or laptops. Do not connect any consumer electronics to the USB port.
16 Synergy Automatic Standby Generator Owner's Manual