Generac G0060980 Manual Del Propietário página 40

Maintenance
Pull up rubber flap covering fuse holder and install 7.5 amp fuse.
11.
Follow Install Wizard instructions using LCD screen and control pad.
12.
Press MANUAL on the control pad to start the engine. A blue LED illuminates to confirm that the system is in the
13.
MANUAL mode.
Allow the unit to warm up for a few minutes.
14.
Press OFF on the control pad to stop the engine. A red LED illuminates to confirm that the system is in the OFF
15.
mode.
Turn on the utility power to the transfer switch.
16.
Move the Generator Disconnect Circuit Breaker switch to the ON (Closed) position.
17.
Press AUTO on the control pad to stop the engine. A green LED illuminates to confirm that the system is in the
18.
AUTO mode.
The generator is ready for service.
NOTE: When a battery is dead or has been disconnected, the exercise timer and current date and time must be reset.
34 Synergy Automatic Standby Generator Owner's Manual