External Control - JVC DT-R24L41D Manual De Instrucciones

Menu Confi guration (cont.)
SIZE/POSI. ADJ.
Adjusts the size and position of the picture.
Item To do
H SIZE Adjust the horizontal picture size.
*1
H POSITION Adjust the horizontal picture position.
*1
V SIZE Adjust the vertical picture size.
*1
V POSITION Adjust the vertical picture position.
*1
sub menu Display the sub menu which enables you to adjust the items of "SIZE/POSI. ADJ." while viewing the actual picture.
reset Restore the default settings for all the items in "SIZE/POSI. ADJ."
Memorized for each signal format.
*1
WHITE BALANCE SET.
Selects the color temperature and adjusts the drive level and cutoff point of each color (R/G/B).
Item To do
COLOR TEMP. Select the color temperature.
R DRIVE Adjust the drive level of each color (red, green, and blue).
G DRIVE
B DRIVE
*2
R CUT OFF Adjust the cutoff point of each color (red, green, and blue).
G CUT OFF
B CUT OFF
*2
sub menu Display the sub menu which enables you to adjust the items in "WHITE BALANCE SET." while viewing the actual
picture.
reset Restore the default settings for the drive levels and cutoff points of the selected color temperature.
Memorized for each color temperature.
*2
REMOTE SETTING
(☞ "External Control" on pages 18 to 21)
Settings for the external control
Item To do
SERIAL TYPE Select the input terminal used for external control by serial communication.
PARALLEL TYPE Select the external control method for the MAKE/TRIGGER terminal.
PIN1 Assign the control functions to the pins of the MAKE/TRIGGER terminal.
PIN2 • Assign a function to each pin terminal by selecting "SET" in "PARALLEL
PIN3 TYPE" mentioned above.
PIN4
PIN5
PIN6 The functions are assigned for "PIN6" – "PIN8" and you cannot change the
PIN7 assignment of these functions.
PIN8
16
Setting value
Setting value varies depending on
the signals.
Setting value
9300K, 6500K, USER
MIN – 000 – MAX (in 256 grades)
MIN – 000 – MAX (in 256 grades)
Setting value
RS232C, RS485
MAKE, TRIGGER, SET
☞ "Functions controlled by the
MAKE/TRIGGER system" on page
19
☞ "Using the MAKE/TRIGGER
system" on page 18