Installation - JVC DT-R24L41D Manual De Instrucciones

Installation

CAUTION
• Do not rest your arm on the monitor or lean against the monitor.
• Do not touch the LCD panel when installing the monitor.
• Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.
To install the monitor on a shelf or any other
suitable surface using screws
You can install the monitor without protruding the stand bottom plate
by moving the stand bottom plate to the rear position.
CAUTION
• Lay the monitor on a cloth with the LCD panel facing down to
prevent the LCD panel from being damaged.
• After moving the stand bottom plate to the rear position, be sure to
attach the stand with commercially available screws.
1
Loosen the stand screws on the stand support and remove the
bottom plate.
Stand support
2
Temporarily set the stand screws to screw holes "3" on the right
and left sides of the stand support.
• Tighten the temporarily set stand screws so that they protrude
from the screw holes by about 4 mm.
Screw holes "3"
3
Hook right and left recesses "A" onto the temporarily set screws in
the stand support.
Recesses "A"
To detach the stand
CAUTION
Lay the monitor on a cloth with the LCD panel facing down to
prevent the LCD panel from being damaged.
Attachment screws
Screw holes for stand
attachment
Monitor
The illustration of the monitor is of DT-R24L41D.
6
4
Adjust the position so that the screw holes on the stand support
align with right and left screw holes "C" and "E" on the bottom
plate, tighten the two stand screws on one side (four screws on
both sides), and fi nally retighten the temporarily set screws to lock
the stand support and the bottom plate.
Screw hole "C" and "E"
Bottom plate
5
Use no less than two commercially available screws (no less than
four screws on both sides) for the screw holes (10 – φ8) on the
stand bottom plate, to anchor the monitor. (Use screws having
enough holding strength and resistance against external force of
expected vibrations.)
CAUTION
It is very dangerous not to anchor the stand with screws as
this may cause not only breakage due to the monitor falling or
dropping, but also injury or electrical shock.
To install the stand
When attaching the stand to the monitor, insert the guides of the
stand into the guide holes on the monitor to place the stand in the
correct position. Then fi x the stand fi rmly with the attachment screws.
Stand body
10 – φ8
Guide holes
Guides
Monitor
Screw holes for
stand attachment
Stand support
Stand body
The illustration of the monitor is of DT-R24L41D.