Stihl TSA 230 Manual De Instrucciones página 41

Power consumption: 570 W
Charge current: 12 A
Insulation: II, E (double
insulated)
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Max. spindle speed:
Outside diameter:
Max. thickness
Bore diameter/spindle
diameter:
Tightening torque:
Composite resin abrasive wheels
Minimum outside diameter
of thrust washers:
Max. depth of cut:
Diamond abrasive wheels
Minimum outside diameter
of thrust washers:
Max. depth of cut:
Weight
without battery, without
abrasive wheel, with water
connection
TSA 230
Water supply
Max. pressure of water
supply:
Transporting Batteries
STIHL batteries comply with the
requirements set forth in UN-Manual
ST/SG/AC.10/11/Rev.5/Part III,
Subsection 38.3.
Commercial air, vessel and ground
transportation of lithium ion cells and
6650 rpm
batteries is regulated. The battery is
230 mm
classified as a UN 3480, Class 9,
(9 ")
packaging group 2 product. Shipping it,
3 mm
either as a complete tool or the battery,
22.23 mm
requires compliance with all applicable
(7/8 ")
shipping regulations. Check with the
ground, vessel, air cargo or passenger
20 Nm
airline to determine if transport is
(177 lbf. in.)
prohibited or subject to restrictions or
exemptions prior to shipping or travel.
80 mm
Normally, no further conditions have to
(3.150 in.)
be fulfilled by the user to transport
70 mm
STIHL batteries by road to the power
(2.756 in.)
tool's operating site. Check and comply
with any special regulations that may
apply to your situation.
80 mm
(3.150 in.)
70 mm
(2.756 in.)
3.9 kg
(8.6 lbs.)
FCC 15 Compliance Statement for
Power Tool and Charger
4 bar
This device complies with part 15 of the
(58 psi)
FCC Rules. Operation is subject to the
following two conditions:
this device may not cause harmful
–
interference.
this device must accept any
–
interference received, including
interference that may cause
undesired operation.
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
reorient or relocate the receiving
–
antenna,
increase the separation between
–
the equipment and receiver,
English
39