Connecting Charger To Power Supply; Charging The Battery - Stihl TSA 230 Manual De Instrucciones

English
1
Press and hold the spindle locking
N
mechanism (1)
Turn the shaft with the combination
N
wrench until the shaft is blocked
Tighten the hexagon head screw
N
with the combination wrench – if
using a torque wrench, refer to the
"Specifications" for the tightening
torque
WARNING
Never use two abrasive wheels at the
same time. The uneven wear creates a
risk of breaking and an injury hazard!
30
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
2
time.
1
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in a closed, dry
space at ambient temperatures between
41 °F (5 ° C) and 104 °F (40 °C).
Only charge dry batteries. Allow a damp
battery to dry before charging.
Slide the battery (1) into the
N
charger (2) until you start to feel
resistance – then push it in until it
engages.
2
TSA 230