Programming The Coffee Temperature - illy Ese Instrucciones De Uso

EN
After making a cup of coffee, the used E.S.E. pod must be expelled as follows:
The used E.S.E. pod drawer can hold a maximum of 9 E.S.E. pods, so it is advisable to empty it regularly to prevent the E.S.E. pods from getting stuck.

PROGRAMMING THE COFFEE TEMPERATURE

Turn the machine OFF using the main switch.
24
• Lift the opening/closing lever fully (the E.S.E. pod will fall into the relative container).
CAUTION: in the interests of hygiene, it is advisable to remove the E�S�E� pod at the end of each delivery and dispense a small
amount of water to remove any residue�
The specific E.S.E. pod container can hold up to 9 used E.S.E. pods. Empty this container on a regular basis.
• If you want to make another coffee, fit a new E.S.E. pod and repeat the procedure, otherwise close the lever.
To perform this operation, remove the tray
1
and separate it from the E.S.E. pod drawer by
pushing it downwards; be aware that there
may be liquid in the tray.
1
With the machine off, press the
5 times to access the temperature change
function. The and buttons will begin
to flash.
2
button Press the button to increase the temper-
ature by 3 degrees. Press the
decrease the temperature by 3 degrees.
Empty the drawer and rinse and dry the
2
components before replacing them in their
housings.
3
PLEASE NOTE: The factory-set
temperature can be increased and/
or reduced by 3°C or 6°C�
button to