Making The Handset Ready For Service; Removing The Protective Film; Inserting The Batteries; Deactivating/Activating The Handset - Siemens Gigaset CL1 Manual Del Usuario

Making the handset ready for service

Making the handset ready for service
The pack contains:
Gigaset CL 1 handset
N
Power supply unit with power cord
N
Two batteries
N
Charger
N
Operating instructions
N

Removing the protective film

The display is protected by a plastic film. Please remove the protective film!

Inserting the batteries

Insert the batteries the right way round – see illustration left.
N
Place the cover on the battery compartment about 3 mm down from the latch and
N
push it up until it clicks into position.
To open the cover, press on the indentation and push downwards.
Insert only approved, rechargeable batteries of the same type
N
(page 19)! Never use normal batteries, since these could lead to a
W
health hazard or cause injury.
Do not use a non-Siemens charging unit as this could damage the
N
batteries.

Deactivating/activating the handset

To switch the handset on or off, press the end call key
Afterwards the confirmation tone rings (see page 9). A deactivated handset activates
automatically when placed in the charging shell.
6
a
.