Registering The Handset On The Base; Charging Batteries - Siemens Gigaset CL1 Manual Del Usuario

Registering the handset on the base

You must initiate handset registration on the handset and on the base.
1. On the handset
[_______________]
MENU
[__________] [______________________________________________] [__________]
REGISTER HS
[______]
OK
During the following registration process, all symbols will flash in the display.
2. At the base
Within 60 secs. of entering the system PIN:
Press the registration/paging key on the base for approximately 3 seconds (see also the
operating instructions for the base). The registration process then starts. When
registration is successful, the handset is automatically assigned the lowest unassigned
number.

Charging batteries

Leave the handset in the charger for the batteries to charge - the batteries are supplied
uncharged. The battery charging process is indicated on the handset by a flashing
V
battery symbol .
Once the batteries have been charged, your phone is ready for service. You need to set
the date and time to ensure that the time of incoming calls can be noted correctly
(page 11).
We recommend initially charging the batteries without interruption for the amount
N
of time listed in the table (page 19) – irrespective of the charging status icon! After
a while the charge capacity of the batteries will decrease for technical reasons.
Once initial charging is complete, you can replace your handset in the charger after
N
each call. Charging is controlled electronically. This ensures optimum battery
charging without overloading.
The batteries heat up during charging. This is normal and not dangerous.
N
Making the handset ready for service
Press display key to open menu.
Select the menu item and confirm.
OK
Enter the system PIN for the base station (default
setting: 0000) and confirm.
7