Stihl FCB-KM Manual De Instrucciones página 12

English
Adjust correctly
3
B
The depth of cut is influenced by uneven
ground as well as height and working
position of the operator. For this reason,
adjust the wheel (2) so that the
N
blade (3) barely touches the ground
when the machine is held in a
normal working posture or
penetrates the ground at most to a
depth (B) of 5 mm.
10
Tighten wingnut clockwise
N
Standing in the normal working
N
position, check the depth of cut
again – correct it if necessary
2
WARNING
Do not adjust the deflector.
The deflector has been set by the
manufacturer so that the arrow on the
deflector and the open side point away
from the operator. This ensures that
cuttings and other debris will be directed
away from the machine and operator.
Edging
Start the engine
N
Start the cut at at least half throttle
N
and continue cutting at full throttle
Hold and guide the unit so that the
N
blade is vertical
Cut steadily so that the engine
N
speed does not decline to any major
extent – do not apply force
Cut at a normal walking pace
N
Do not push the blade into the
N
ground
Always walk forwards when cutting,
N
do not pull the unit towards you
Cut at a steady pace – this avoids
N
having to make several passes
FCB-KM