Mounting The Kombitool; Mounting The Cutting Blade - Stihl FCB-KM Manual De Instrucciones

English
2
4
Align the gearbox (2) on the shaft so
N
that the rib (4) is in line with the
shaft.
Tighten the clamping screw firmly.
N
12

Mounting the KombiTool

2
1
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
3
4
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.

Mounting the Cutting Blade

Place the edger so that the blade
N
mounting (1) faces upwards
5
6
4
2
3
Insert the locking pin (2) as far as
N
possible into the bore (3), push
lightly and rotate back and forth a
little together with the thrust washer
(4) until the shaft is blocked.
Fit Allen wrench (5) onto nut (6).
N
FCB-KM