Britax ONE4LIFE CLICKTIGHT Guia Del Usuario página 12

Vehicle Headrest
In some cases, the vehicle headrest
can prevent the child restraint
headrest from being raised high
enough to properly adjust the
harness for the fit of your child when
using a forward-facing reclined
position. DO NOT force the child
restraint headrest past the vehicle
headrest. Doing so could cause the child restraint not
to perform as intended. If the location of the vehicle
headrest interferes with the child restraint headrest, raise
or remove the vehicle headrest. If the vehicle headrest
can not be removed, move the child restraint to the
upright position or try a different seating location.
Incompatible Vehicle Seat Belts
The following types of vehicle seat belts are NOT compatible
with this child restraint. If any of the belt types listed below
are in the chosen seating position, choose another vehicle
seating position or check your vehicle owner's manual for
information on installing a car seat in your vehicle.
Lap belts with a sewn-in
latch plate that have a
retractor that locks only
in case of a sudden stop.
Lap-shoulder belts with
top or bottom anchor
points on the vehicle door.
NOTE: This Britax child restraint may not be compatible
with every inflatable lap-shoulder belt. See FAQs in the
support section of the Britax website (us.britax.com/faqs) for
additional instructions.
10
WARNING!
WARNING!
Lap belts forward of the
vehicle seat bight.
Motorized, automatic
vehicle seat belts.