Britax ONE4LIFE CLICKTIGHT Guia Del Usuario página 37

3. Open the chest clip by
squeezing the tabs (A)
and pull apart (B).
4. Release the buckle and
place the harness straps
to the side.
5. Place child in the child
restraint. Ensure the child
is positioned upright in
the child restraint and not
slouching. Their bottom
must touch the child
restraint, and their back
must rest flat against the
back of the child restraint.
6. Position the harness
straps around the child.
NOTE: Remove bulky
coats and/or jackets
before putting the child
in the child restraint.
7. Fasten the buckle. Proper
connection is confirmed
with a click after inserting
each buckle tongue.
8. Check the proper harness
height and pull any excess
slack up to the child's
shoulder area before
tightening.
9. Pull the harness adjuster
strap to tighten the harness.
NOTE: The harness should
have a snug fit around the
child. A snug strap should
not allow any slack. It lies
in a relatively straight line
without sagging. It does not
press on the child's flesh or
push the child's body into
an unnatural position. You
should not be able to pinch
excess webbing.
10. Fasten the chest clip and
place at armpit level.
B
A
35