Booster Mode Installation - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Vehicle belt is locked as directed by your vehicle owner's manual.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for FORWARD-
facing, after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 The anti-rebound bar MUST be removed.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.

BOOSTER Mode Installation

IMPORTANT:
should remain in a child seat with a 5-point harness until
reaching the maximum weight or height allowed.
Use in BOOSTER
• in recline position "B", and
• with children who weigh 40 - 120
lb (18.1 - 54.4 kg), and
• when top of child's ears are
BELOW the top of headrest, and
• when the lap belt sits low across
child's upper thighs when routed
through the belt guide, and
• when the vehicle shoulder belt lays straight across the
child's chest, and
• when the shoulder belt guides are positioned above the
child's shoulders.
Using Lower Anchors and Top Tether (LATCH) in BOOSTER
Mode
Use of lower anchors and top tether is not required for
booster seat installation. However, lower anchors and top
tether can be used to secure child restraint in
mode. ALWAYS make sure the child restraint system is
secured to the vehicle, even when unoccupied, since in
a crash, an unsecured child restraint system may injure
occupants.
To use this seat in
see instructions for Securing Your Child in Booster Mode on
page 36.
Britax strongly recommends that children
mode only:
BOOSTER mode without lower anchors,
BOOSTER
31