Britax ONE4LIFE CLICKTIGHT Guia Del Usuario página 22

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing,
after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 1 in. (2.5 cm) at the belt path.
9 Both vehicle lap and shoulder belts are routed through the CLICKTIGHT.
9 Excess top tether webbing is contained within your vehicle and secured.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.
Installation with Lower Anchor Connectors (LATCH)
Do NOT install by this method for a child weighing more
than 30 lb (13.6 kg).
1. Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
2. Open the storage
pocket. Remove the
lower connectors by
pushing the red buttons
and pulling away from
the child restraint.
3. Extend lower connector
strap to its longest
length by pressing grey
button on the lower
connector adjuster.
4. Place the child restraint
REAR-facing on vehicle
seat so that the car seat
base is flat on the vehicle
seat and is parallel to
vehicle seat.
5. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
20