Burner Connection To The Boiler - baltur TBML 80 ME Manual Instrucciones De Uso

10
8
6
4
2
TBML 160 MC - 200 MC OPERATING RANGE
0
100 200 300 400
mbar
15
14
12
10
8
6
4
2
0
300 400 500 600
Thermic power TBML 200 gpl = 1930kW
The operating ranges are obtained from test boilers corresponding to
Standard EN 267 and are indicative of the combination burner-boiler.
To ensure correct burner operation, the dimensions of the combustion
chamber must comply with current regulations; if this is not the case,
consult the manufacturers.

BURNER CONNECTION TO THE BOILER

ASSEMBLING THE HEAD UNIT
• Adjust the position of connector flange 5 by loosening the
screws 6 so that the combustion head penetrates the advised
amount into the combustion chamber as recommended by the
generator's manufacturer.
• Position insulating seal 3 on the sleeve, placing cord 2 between
the flange and the seal.
• Fasten the Combustion Head unit 4 to the boiler 1 by means of
the stud bolts, washers and the nuts provided 7.
Completely seal the space between the burner sleeve and
the hole in the refractory material inside the boiler door with
suitable material.
500 600 700 800 900
TBML 160
700 800 900 1000 1100
0006160035_201408
1000 1100 1200 1300 1400
TBML 200
1200 1300 1400 1500 1600
Thermal power of methane gas
Thermal power of diesel oil
8 / 36
kW
1700 1800 1900 2000 2100
kW