Baxi CBP Matic 18 Manual De Instrucciones página 209

d) e)
Figure 24 – Connecting the sensors to the circuit board
2 – Next, you should remove the storage unit's level sensor. By default, it comes
installed on the left side of the storage unit (the storage unit is set up by default to be
installed on the right side of the boiler). To do this, loosen the screws of the part that
supports the sensor and remove the set.
Figure 25 – Removing the storage unit's level sensor
3 – With the sensors already connected to the circuit board, you must connect the
boiler to the mains.
4 – You should put some pellets in a container, and next to the boiler, perform the
sensitivity adjustment, as described in the following steps:
- put the sensor over the pellets;
46