Baxi CBP Matic 18 Manual De Instrucciones página 220

3 – To place the pellets' output on the right side of the storage unit,
loosen both screws shown in Figura 41-a (you don't need to remove
them completely), and rotate the channel upper assembly (including
the drive's assembly) clockwise. Once the procedure is completed,
retighten the two screws.
4 – Afterwards, you must slide the worm drive channel to the right side of
the storage unit (Figura 42-a), by lifting it up and rotating it clockwise
so that it fits the base aligned diagonally with the holes (Figura 42-b).
a)
Figure 40 – Removing the side lids and plate
a)
Figure 41 – Worm drive set rotation
b)
b)
57