Baxi CBP Matic 18 Manual De Instrucciones página 230

A cleaning the burner and the plate, as shown in the figures, 56-b, 56-c and 56-d to
prevent obstruction of the holes in the burner or some kind of residue ashes must not
be made to be gripped plate cleaning.
a) b)
c) d)
Figure 56 - Cleaning the burner and plate
WARNING! the frequency of maintenance tasks is dependent on the
quality of pellets
Additional cleaning
Additional cleaning should be carried out for every 2000 Kg of pellets consumed.
The boiler's air pipes and respective turbulators must be cleaned. To do this, start by
opening the lid located on the top of the unit (Figura 57-a) and removing the six
butterfly nuts securing the lower lid (Figura 57-b e c). Next, pull up the turbulators
(Figure 57-d), also removing the spring support (Figure 57-f). A vacuum cleaner
should be used to clean this area and the interior of the pipes may be cleaned using
a steel brush (Figure 57-g) The turbulators and springs previously removed should
also be cleaned with a steel brush.
To reinstall the turbulators, execute in reverse the above procedure shown in the
figures.
67