Application 2; Application 3 - Rotex RKHBRD011AAV1 Guia De Instalacion

Ocultar thumbs Ver también para RKHBRD011AAV1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 203

Application 2

Space heating and domestic hot water heating with one remote
controller installed with the unit, and another remote controller
installed in the living room.
C2
1
12
2
3
12
4
5
8
1
Outdoor unit
2
Indoor unit
3
Refrigerant heat
exchanger
4
Water heat exchanger
5
Compressor
6
Pump
7
Shut-off valve
8
Motorized 3-way valve
(optional)
9
Domestic hot water tank
(optional)
The remote controller gives immediate feedback to the indoor unit
and by doing so it matches in a smart way the unit performance to
the demanded space heating requirements. In this way there is no
frequent start/stop of the unit or there are no too big temperature
fluctuations in the to be heated rooms. This remote controller has
also a smart logic functionality which controls the combined space
heating and domestic hot water demand (e.g. if room temperature
drops more than 3°C during domestic hot water operation, the unit
will automatically switch back to space heating). The main remote
controller (C1) is installed in the living room and can access all
settings (master). The second remote controller (C2) can not access
schedule and parameter settings (slave).
Operation ON/OFF
Domestic water heating operation ON/OFF
Setting the leaving water temperature
Setting the room temperature
Quiet mode ON/OFF
Weather dependent set point operation
ON/OFF
Setting the clock
Programming the schedule timer
Schedule timer operation ON/OFF
Field settings
Error code display
Test operation
Room thermostat functionality
Refer to the chapter "Electrical wiring work" on page 13 about
connecting the master and slave remote controller.
RKHBRD011~016AAV1+Y1
Indoor unit for air to water heat pump system
4PW55786-1
A
B
C1
6
7 7
10 13
M
11
9
10
Collector (field supply)
11
Radiator (field supply)
12
Electronic expansion valve
13
By-pass valve (field
supply)
C1
Remote controller (master)
C2
Optional remote controller
(slave)
A
Installation place
B
Living room
Master
Slave
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable
Operable

Application 3

Space heating and domestic hot water heating with a single remote
controller installed with the unit, and the external room thermostat
installed in the living room.
Optionally the Rotex room thermostat RKRTR or RKRTW
can be connected to the Rotex system. Rotex can not
guarantee neither good operation nor reliability of the
system if another thermostat is used. For those reasons
Rotex can not give warranty of the system in such case.
C1
1
12
2
3
12
4
5
1
Outdoor unit
2
Indoor unit
3
Refrigerant heat exchanger
4
Water heat exchanger
5
Compressor
6
Pump
7
Shut-off valve
8
Motorized 3-way valve
(optional)
9
Domestic hot water tank
(optional)
There is only a room thermostat on/off control. There is no smart
logic functionality for space heating. The domestic hot water
operation is performed according to the minimum and maximum
timer operation.
A
B
T
6
7 7
10 13
M
11
8
9
10
Collector (field supply)
11
Radiator (field supply)
12
Electronic expansion
valve
13
By-pass valve (field
supply)
C1
Remote controller
T
Room thermostat
A
Installation place
B
Living room
Installation manual
3

Publicidad

Tabla de contenido
loading

Tabla de contenido