Wheel Cleaner/Intensive Foam (Option); Micro Emulsion (Option) - Kärcher SB MU Manual De Instrucciones

Wheel cleaner/intensive foam
(option)
1 Input of detergent
2 Nozzle insert
3 Suction hose for detergent
 Pull off the suction hose.
 Select the nozzle insert for the desired
mixing ratio:
Nozzle colour Water/detergent
Wheel
cleaner
no nozzle 1:1
grey 1.2:1
black 2:1
beige 4:1
red 6:1
white 9:1
blue 10:1
light brown 13:1
green 21:1
orange 26:1
brown 30:1
yellow 38:1
purple 50:1
pink 100:1
Basic setting water/chemicals
Rim clean-
er
Detergent RM 801
Nozzle colour blue
Mixing ratio 10:1
 Slide the nozzle insert all the way into
the detergent input.
 Insert the suction hose.
1 Adjustment screw
 Adjust the pressure via the adjustment
screw:
Rim cleaner Intensive foam
5,5...6,5 bar 8.0...8.5 bar
Basic setting air
 Adjust the air pressure reducer:
Rim cleaner
2.5...3.0 bar
ATTENTION
Risk of damage due to acidic detergents.
Only use alkaline detergents for wheel
cleaning.
Note:
After performing the basic setup, the spray
pattern should only be changed by adjust-
ing the pressure reducer for air.
Wheel cleaner:
The uniform application onto the rims is fa-
cilitated if a suitable colouring agent is add-
ed to the rim cleaner concentrate.

Micro emulsion (option)

Intensive
foam
4:1
5:1
6:1
8:1
17:1
1 Adjustment screw
23:1
25:1
 Adjust the pressure of the micro emul-
36:1
sion as needed by turning the adjust-
ment screw.
48:1
64:1
75:1
90:1
120:1
240:1
Intensive
foam
RM 838
yellow
90:1
1 Key "1/ON"
2 Control lamp operating state
3 Display
4 LEFT key
5 RIGHT key
6 OK button
7 ESC button
During normal operating mode, the control
panel display alternates between:
Day of the week, date, time, summer time
(Som)/winter time (Wint)
Intensive foam
3.0 bar
Controls
6
-
EN
Operating time of the system on the current
day
Maintenance work due from customer ser-
vice (example).
If more than one maintenance procedure is
required, these will be shown in sequence.
If no maintenance procedures are required,
nothing will be shown.
Fault occurred (example).
If more than one fault is present, these will
be shown in sequence.
The number in parentheses shows the total
number of faults present.
If no faults are present, nothing will be
shown.
NOTICE
To acknowledge faults see "Fault assis-
tance"
Open the menu "customer settings"
 Press OK button for more than 2 sec-
onds.
 Press the RIGHT button.
 Press the OK button.
The menu "customer settings" (see follow-
ing page) has been reached.
43