Settings 1 Menus - Jacuzzi J-400 Manual De Instalacion Y Uso & Mantenimiento

Adjusting Individual Jet Flow
The water flow to the individual jets in your spa can be increased
or decreased by rotating the outside jet face.
N.B.: always keep at least 6 of these jets open so as to ensure
efficient water filtering.
Adjusting PowerPro Jets
I
Tilt Jet nozzle to angle of choice as desired. Rotate nozzle
clockwise to reduce flow volume from jet or rotate counter-
clockwise to increase it.
N.B.: Always keep at least 6 adjustable jets open at all times.
Adjusting RX Jets
I
Turn the centre knob clockwise to reduce and/or close the flow
of the jet. Turn it counter-clockwise to open and/or increase the
flow of water.
N.B.: Always keep at least 6 adjustable jets open at all times.
Waterfall Feature
I
Turn waterfall control valve counterclockwise to increase
waterfall output. Turn control valve clockwise to decrease or turn
off waterfalls.
Air Controls
Some jets have individual air regulation.
I
Rotate the air controls in an anticlockwise direction to close
and in a clockwise direction to open.
N.B.:To minimize heat loss, all air controls should be closed
when the spa is not in use.

Settings 1 menus

I
Press button D from the Main Menu to enter the Settings 1
Menu.
From this menu you can choose a heating cycle, set the timer
for the CLEARRAY Water Purification System, and set the chan-
ge/clean filter reminder.
A
1
B
2
Heating Menu: Press button A to access the heating
programs.
Filter Boost: Press button C to activate the filter boo-
st cycle. All the jets pumps will activate for 20 minutes for ad-
ditional filtering. The display will read "Filter Boost Enabled" and
revert to the "Settings 1" Menu within 5 seconds.
2
Settings 2 Menu: Press button B to access the addi-
tional programming features.
Previous: Press button D to return to the previous menu.
Programming the Eco-Mode Heating Mode
Eco-Mode is an energy saving heating program. By heating the
spa in the non-peak hours, you conserve electricity. While in E-
co-Mode the spa is programmed to heat during the hours of
5:00 PM to 7:00 AM on a daily basis. The functions for this mo-
de cannot be altered.
From the "Settings 1" menu, press button A to enter the Hea-
ting programs. The menu appears with Eco-Mode selected.
HEATING
Eco-Mode
ENERGY EFFICIENT
Auto-Heating
Programmable
Press to Save
2
If you elect to use this mode, press the Splash button on the
Quad Keypad. The display will confirm your selection and will be
displayed briefly then return to the Heating submenu.
To exit the submenu, press button D to return to the Settings 1
menu.
If you have programmed Eco-Mode cycle you will see the Eco-
Mode icon next to word Heating on the display.
66
SETTINGS 1
Heating
ENERGY EFFICIENT
UV Light
0 Days
Filter
OFF
Press to
set filter or UV timer
ECO-MODE
Eco-Mode Enabled
Select
ENERGY EFFICIENT
C
D