I
Via the multifunction keyboard it is also possible to:
• increase the volume (upper zone of keypad)
• decrease the volume (lower zone of keypad)
• select the previous track (left zone of keypad)
• select the next track (right zone of keypad)
• temporarily suspend/restart playing the track (central key of keypad)
I
To return to the main menu press the "Return" key; to turn off
press the central key for approximately 3 seconds).
Internal memory (NAND)
I
Select the "USB" symbol on the remote control and press the
upper zone of the multifunction keypad: the display will have
the following configuration (use the multifunction keypad to
scroll the list of the files and the files contained internally):
I
Via the multifunction keyboard it is also possible to:
• increase the volume (upper zone of keypad)
• decrease the volume (lower zone of keypad)
• select the previous track (left zone of keypad)
• select the next track (right zone of keypad)
• temporarily suspend/restart playing the track (central key of keypad)
I
To return to the main menu press the "Return" key; to turn off
press the central key for approximately 3 seconds).
Auxiliary devices (AUX)
I
Select the "AUX" symbol on the remote control display; via the
multifunction keypad it is possible to:
• increase the volume (upper zone of keypad)
• decrease the volume (lower zone of keypad)
I
To return to the main menu press the "Return" key; to turn off
press the central key for approximately 3 seconds).
iPod
I
Select the "iPod" symbol on the remote control display that
will be shown as follows (the track number could be different):
iPod
I
Via the multifunction keyboard it is also possible to:
• increase the volume (upper zone of keypad)
• decrease the volume (lower zone of keypad)
• select the previous track (left zone of keypad)
• select the next track (right zone of keypad)
• temporarily suspend/restart playing the track (central key of keypad)
I
To return to the main menu press the "Return" key; to turn off
press the central key for approximately 3 seconds).
Error messages
If the remote control detects an error condition the display will show
the "SPA-Err" (one word at a time).
I
Approximately 20 seconds after the error appears the light of
the remote control begins to flash until another key is pressed.
Please refer to the control panel for other indications.
Replacing the remote control batteries
- Turn the remote control over and locate the battery housing;
remove the cover by removing the screws (insert the point of a
screwdriver underneath the cover to aid removal).
- Replace the batteries (AAA type) and replace the cover.
Note: the remote control is water resistant (but not water ti-
ght); store in a dry place when not in use . Do not leave in the
spa underneath the cover.
85