Spa Maintenance - Jacuzzi J-400 Manual De Instalacion Y Uso & Mantenimiento

1.
A
B

Spa maintenance

I
Cleaning the filters
A programmable reminder "Filter change" (refer to the "Filter
cartridge Promemoria" chapter) flashes on the control panel dis-
play after a number of days to remind you to clean the filter of
the skimmer and check the cleaning sack filter.
This reminder must be reset at each filter cleaning interval.
Your new spa is equipped with an advanced 2-stage filtration sys-
tem. Fine debris is filtered by the circulation pump drawing water
through the skimmer and pleated filter cartridge every 12 hours
(unless programmed otherwise). Large debris are filtered when
either jets pump is running when the spa is in use or during a
programmed filter cycle. These pumps draw water from footwell
suction fitting and through a secondary water polishing bag fil-
ter. The exclusive footwell "sweeper" suction fitting enhances fil-
tration in the footwell area by creating a "swirling" water motion
to maximize particle agitation and pickup.
To ensure optimum performance, the cartridges (A) and (C) must
be cleaned every three months and replaced once a year and the
secondary polishing filter bag (B) should be emptied weekly and
replaced every 3 months.
C
A
B
Note: attempts to wash the part (B) may make it unusable.
ALWAYS TURN POWER TO THE SPA OFF BEFORE
CLEANING THE FILTER CARTRIDGES!
To accomplish this, refer to the following filter cleaning procedure:
1. Remove power to the hot tub before removing the skimmer
(A) or filter bag cover (B).
2. Remove the polishing bag lid (B) by rotating it counterclock-
wise approximately 5 degrees until you feel it unlatch.
2.
5.
3.
4.
3. Remove the polishing bag by reaching into the filter bucket
and gently pulling upward on the blue filter ring (check and
empty filter monthly)
Note: the filter (C) is located under the bag: to remove it, turn
it counterclockwise, and clean it following the instructions pro-
vided in point 6.
Replace bag, then install filter lid by rotating it clockwise until
you feel it latch in place.
DO NOT FORCE LID! FINGER TIGHT ONLY!
4. Remove the skimmer assembly (A) by gently lifting upward
from the filter bucket.
5. Remove the filter cartridge by rotating it counterclockwise to
unthread it, then remove the center cap and chemical dispenser
from the filter cartridge as shown (right).
6. Clean the filter cartridges and filter canister with a garden
hose and high pressure nozzle. Rinse debris from the filter pleats
beginning at the top and working your way downward.
Continue, one section at a time until you have cleaned all debris
from the filter pleats. When replacing the filter cartridge, make
sure you remove the center cap and chemical dispenser for use
with the new cartridge.
Replacement filter cartridges may be purchased from
your authorized Jacuzzi dealer.
A
B
C
72
C
A
B
D
E
F