English
Vehicle configuration (Continued)
EN
A
B
C
D
E
F
Positioning of the vehicle safety hook, front to back
Check the front to back and side to side positioning when unloading and loading the cot to make sure that you install the
vehicle safety hook correctly.
To check the front to back positioning:
1.
Select the appropriate vehicle safety hook
2.
Position the vehicle safety hook at least 3-3/4 in. from the leading edge of the door sill (A). The recommended
distance from the face of the safety hook to be no less than 3-3/4 in.
3.
Make sure that you can secure the vehicle safety hook to the mount in the back of the vehicle.
4.
Make sure that you have adequate bumper clearance to allow the cot to be loaded and unloaded from the vehicle.
5.
Confirm the side to side placement of the vehicle safety hook
page
1-11).
1-10
Installation
B
A
Figure 1-4: Deck and bumper height
Deck height (DH)
Bumper height
Vehicle safety hook
Sill edge
Sill
Bumper depth
(Selecting the vehicle safety hook on page
6370-109-005 REV C
C
D
1-8).
(Positioning of the vehicle safety hook, side to side on
E
A
B
F
www.stryker.com