Testing The Cot Fastener - Stryker 6393 Manual De Operaciones

Adjusting the rail assembly (Continued)
G
H
I

Testing the cot fastener

WARNING
Always test the fastener using AMD Standard 004 as a minimum. Improper testing can result in injury.
To test the fastener:
1. Guide the cot into the cot fastener.
2. Make sure that the antler connects with the head end loading wheels of the cot.
3. Make sure that the rail clamp jaws are secure to the center of the cot post.
4. Test the fastener using AMD Standard 004 as a minimum.
Note: The fastener may be put into service after successfully passing steps two and three.
www.stryker.com
Operation
Release button
Moveable jaw
Stationary jaw
Figure 1-24: Guiding the cot into the fastener
6370-109-005 REV C
English
EN
1-25