Installing The Wall Plate - Stryker 6393 Manual De Operaciones

Installing the floor plate (Continued)
12. Install the four Nylock hex nuts (H) and four 5/16−18 x 2 in. socket head cap screws (J) to attach the rail clamp (K)
to the rail assembly (Figure 1-14 on page
Figure 1-13: Fasten the rail support bracket

Installing the wall plate

The Stryker cot fastener system for the wall plate mounting model is compatible only with cots which conform to the wall
plate mounting installation specifications.
To position the antler floor mounting plates:
1. Determine the desired position of the cot inside the vehicle to allow for proper clearance around the cot.
Note: Federal ambulance specifications regarding that aisle width and attendant seating may affect positioning of
the mounting brackets. If specifications do not apply, the installer should be certain that there is adequate
clearance for proper patient access, traction splint projection, rear door closure, etc.
www.stryker.com
Installation
1-17).
Figure 1-14: Attach rail clamp to rail assembly
6370-109-005 REV C
English
EN
1-17