Stryker 6393 Manual De Operaciones página 20

English
Installing the floor plate (Continued)
EN
To position the antler floor mounting plates:
1. Determine the desired position of the cot inside the vehicle to allow for proper clearance around the cot.
Note: Federal ambulance specifications regarding aisle width and attendant seating may affect positioning of the
mounting brackets. If specifications do not apply, the installer should be certain that there is adequate clearance for
proper patient access, traction splint projection, rear door closure, and so on.
2. Using the dimensions shown in
14-5/8" (Ref.)
(37,1 cm)
D
Rail support bracket floor plate
A
B Wall of vehicle
Antler floor plates
C
D Rear of ambulance
3. Cut 1 in. x 2-1/2 in. x 9/16 in. deep recessed openings (A) into the floor centered over the locating holes
on page 1-15).
1-14
Installation
Figure 1-8 on page
A
12-5/8" (32 cm)
2-5/8"
(6,6 cm)
Figure 1-8: Floor plate installation locations
1-14, locate and drill the points where the floor plates will attach.
B
E
F
37-5/8"
(95,6 cm)
80.000 (Ref.)
(203 cm)
E Cot center line
Cot perimeter
F
G Cot head end
6370-109-005 REV C
C
G
24.000
(Ref.)
(61 cm)
6-1/8"
14-15/16"
(15,6
(37,9 cm)
cm)
(Figure 1-9
www.stryker.com