Stryker 6393 Manual De Operaciones página 21

Installing the floor plate (Continued)
4. Using two 3/8 in. diameter socket head cap screws (B), preferably grade 8, anchor each floor plate (C) into the
recessed openings with the counter-bored holes facing up
Note: Steel backing plates (or equivalent) (D) (not supplied) are required for added support
15).
CAUTION
Do not use screws smaller than the 3/8 in. diameter specified to anchor the floor plates.
Figure 1-9: Cut recessed openings over locating
5. Using the dimensions shown in
bracket floor plate will attach. Cut one 2 1/2 in. x 5 in. x 9/16 in. deep opening (E) into the floor centered over the
locating points (Figure 1-11 on page
www.stryker.com
Installation
B
C
A
holes
Figure 1-8 on page 1-14, locate and drill the four points where the rail support
1-16).
6370-109-005 REV C
(Figure 1-10 on page 1-15).
Figure 1-10: Anchor floor plate into recessed
openings
(Figure 1-10 on page 1-
1-15
English
EN