Stryker 6393 Manual De Operaciones página 25

Installing the wall plate (Continued)
4. Using two 3/8 in. diameter socket head cap screws (B) (not supplied), preferably grade 8, anchor each floor plate
(C) into the recessed openings with the counter-bored holes facing up
Note: A steel backing plate (or equivalent) (D) (not supplied) is required for added support
19).
CAUTION
Do not use screws smaller than the 3/8 in. diameter specified to anchor the floor plates.
Figure 1-16: Cut recessed openings over locating
5. Using the dimensions shown in
mounting bracket will attach.
www.stryker.com
Installation
B
C
A
holes
Figure 1-15 on page 1-18, locate and drill the four points where the rail wall
6370-109-005 REV C
(Figure 1-17 on page 1-19).
(Figure 1-17 on page 1-
Figure 1-17: Anchor wall plate into recessed
openings
English
EN
1-19