Installing The Vehicle Safety Hook - Stryker 6393 Manual De Operaciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Positioning of the vehicle safety hook, side to side (Continued)
EN
Notes
If the cot safety bar does not connect with the vehicle safety hook in any of these positions (left, center, or
right), modify the vehicle. Do not modify the cot or the vehicle safety hook.
If the cot safety bar connects with vehicle safety hook every time, install the vehicle safety hook.

Installing the vehicle safety hook

Before installing the vehicle safety hook, the certified mechanic should plan for the placement of the vehicle safety
hook in the rear of the vehicle patient compartment.
WARNING
Failure to install the vehicle safety hook may cause injury to the patient or operator.
Always have a certified mechanic, familiar with ambulance vehicle construction, install the safety hook.
Always make sure that the safety bar connects with the vehicle safety hook before you remove the cot from the
vehicle patient compartment to avoid the risk of injury.
Hardware required (not supplied):
• (2) Grade 5, minimum 1/4"-20 socket head cap screws * for the short vehicle safety hook or long vehicle safety
hook
• (2) Grade 5, minimum 1/4"-20 flat socket head cap screws * for the J vehicle safety hook
• (2) Flat washers
• (2) Lock washers
• (2) 1/4"-20 nuts
Note: The length of the socket head cap screws depend on the thickness of the vehicle floor. Use screws that are long
enough to go completely through the vehicle patient compartment floor, washer, and nut, with at least two full threads in
the nut.
1.
Determine the correct vehicle safety hook front to back and side to side positioning, so the cot safety bar connects
to the vehicle safety hook every time.
Positioning of the vehicle safety hook, front to back on page 1-10
Positioning of the vehicle safety hook, side to side on page 1-11
2.
Drill the holes for the screws.
3.
Fasten the vehicle safety hook to the vehicle patient compartment floor.
4.
Make sure that the cot safety bar connects with the vehicle safety hook before you remove the cot from the vehicle
patient compartment.
1-12
Installation
6370-109-005 REV C
www.stryker.com

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

63706371637763786391

Tabla de contenido