Dust Extraction; Dust Box; Reducer; Use - Parkside PMFS 200 C3 Traducción Del Manual De Instrucciones Original

Dust extraction

WARNING! RISK OF FIRE!
► When working with power tools that have a
dust collection box or can be connected to
a vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e .g . when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust sack (or in the vacuum
cleaner dust bag) can spontaneously ignite .
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time . Therefore, do
not allow the workpiece to overheat and
always empty the dust box or the dust bag
of the vacuum cleaner before taking a break
from work .
Wear a dust mask!
NOTE
► Perforated sanding sheets are required for
dust extraction .

Dust box

Connecting:
♦ Push the dust box
far as the stop .
Removal:
♦ Press the release button
and pull it off towards the rear .
NOTE
► To achieve optimum dust extraction, the dust
box should be emptied regularly .
♦ To do this, remove the dust box
appliance as described above . Open the dust
box by pulling on the tab
the lid . Clean both parts thoroughly by tapping
them out .
PMFS 200 C3
onto the multi-sander as
of the dust box
from the
and then removing

Reducer

Connecting:
♦ Push the reducer
♦ Push the hose of a suitable of vacuum cleaning
appliance (e .g . a workshop vacuum cleaner)
onto the reducer
Removal:
♦ Pull the hose of the vacuum cleaner off the
reducer .
♦ Remove the reducer

Use

CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains .
NOTE
► Always switch the multi-sander on before
applying it to the material, then move it over
the workpiece .

Switching on and off

Switching the appliance on:
♦ Move the ON/OFF switch
Switching the appliance off:
♦ Move the ON/OFF switch

Setting the oscillating speed

You can set the desired oscillating speed using the
speed selector as required . The required speed
depends on the material being processed and can
be determined through practical tests .

Working procedures

■ Switch the appliance on before applying it to
the workpiece .
■ Apply minimal pressure when working .
■ Work at a constant speed .
■ Change the sanding sheets regularly .
into the adapter fitting
.
.
to the "I" position .
to the "0" position .
GB │ MT │
.
43 ■