Eurocave WineArt Modo De Empleo página 25

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5
Commissioning
your Appliance
The air vacuum system status light
lets you know that your wine is being
stored in the best conditions when it stops flashing (green indicator light
permanently on).
If the air vacuum system indicator light
is red, refer to chapter 7.
- Vacuum sealing a bottle repetitively can have an impact on the duration of
preservation of wine.
- To remove the bottle from the appliance, open the compartment door then swivel the
base of the bottle towards the outside of the compartment.
N.B.: The pump will activate itself again (which is normal) for approximately 10 seconds.
Note: Do not insert corks or any other elements that may obstruct the bottle neck, it must
be completely clear. Ensure that the bottle is correctly aligned inside the compartment (see
chapter 5-I Precautions to observe)
2) BRINGING YOUR WINE TO THE CORRECT TEMPERATURE
- To then bring your open bottle to an ideal serving temperature, select the wine mode
corresponding to your bottle by pressing the
button of the compartment concerned
as many times as necessary. The red indicator light indicates that the compartment is in
red wine mode. The yellow indicator light indicates that the compartment is in white or
rosé wine mode. When no indicator light is on, the compartment's serving temperature
mode is not functioning.
Note: the compartment is still in serving temperature mode. To switch off this mode, press
the
key of the compartment concerned as many times as necessary until the indicator
lights turn off.
V – Turning off the appliance / Placing the appliance
on standby
Before unplugging your appliance, ensure that the serving temperature mode is not activated
(red and yellow indicator lights off).
If it is activated, press the
keys several times until all the indicator lights on the control
panel turn off.
Then, to turn off the appliance, simply unplug the mains plug then pull towards you the mobile
section of the power lead identified by the arrow on the top of the plug. Do not use force.
Note: to place the appliance on standby, press the
keys of the two compartments several
times, until the temperature indicator lights go off.
-11-

Publicidad

Tabla de contenido
loading

Tabla de contenido