Mounting The Loop Handle; Adjusting The Throttle Cable - Stihl FC 90 Manual De Instrucciones

English

Mounting the Loop Handle

Mounting the Loop Handle
2
3
A
N Position the loop handle (1) on the
drive tube, about 8 in (20 cm) (A)
forward of the control handle (2).
N Place the clamp (3) against the
drive tube and push it into the loop
handle.
14
1
N
Fit the square nut (4) in the loop
handle, insert the clamp screw (5)
from the other side and tighten it
down firmly.
Adjusting the loop handle
N Line up the loop handle and move it
to the most comfortable position.
N
Loosen the screw (5).
N Move the loop handle along the
drive tube as required – tighten
down the screw firmly.
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
N
4
5
50 mm
( 2" )
N
N
Adjusting the Throttle
Cable
Adjust the throttle cable only when
the unit is completely and properly
assembled.
Use a suitable tool to push the slide
to the end of the slot (see
illustration).
1
2
Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
FC 90