Removing Water From The Tank (Fig. E-4); Water Treatment; Cleaning And Maintenance; Water Changes Colour Or Becomes Cloudy - Tunturi R50W Manual Del Usuario

⚠ WARNING
• Filling the water level over the Maximum
level might result in water leakage during
workout.
- Begin filling the tank by squeezing the siphon.
Use the level gauge decal on the side of the
tank to measure volume of water in the tank.
- After filling the tank to the desired water level,
open the valve on the top of the siphon to
allow excess water to escape.
- Ensure that the tank plug is replaced once
filling and water treatment procedures are
complete.
removing water from the tank (fig�
E-4)
- Remove the tank plug (21).
- Insert the siphon rigid hose end into the tank
- Insert the siphon flexible hose end into a large
bucket.
- Drain the tank (approx. 20% of water will remain
in the tank. It is not possible to drain the tank
completely without disassembling the tank)
- Refill the tank following the directions as
described under the section "Filling the tank"
of this manual.
NOTE
• The valve on top of the siphon must be
closed to allow proper drainage.
• If the water treatment schedule is
maintained, it will not be necessary to
change the water inside the tank. An
additional water treatment tablet is only
required when discolouration of the water
appears.
• Exposure to sunlight affects the water.
Moving the rower away from direct sunlight
will extend time between water treatments

Water treatment

- Add one water treatment tablet.
- Add a water treatment tablet whenever the
water appears dirty or cloudy over time.
⚠ WARNING
• Only use the Tunturi supplied water
treatment tablets.

Cleaning and maintenance

The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent
cloth after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.
⚠ CAUTION
• Avoid dirt on the seatroller track. Dirt can
cause roller track damage, resulting in
quality issues.
Water changes colour or becomes
cloudy
Possible cause:
Rower is in direct sunlight or has not had water
treatment.
Solution:
- Change rower location to reduce direct
exposure to sunlight.
- Add water treatment or change tank water as
directed in the water treatment section of this
manual.

Troubleshooting

Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective
part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also
the nature of the problem, conditions of use and
purchase date.
English
13