User Data; Additional Information; Battery - Oregon Scientific SE128 Manual De Usuario

• Press ST/SP to start the stopwatch.
• Press ST/SP to stop the stopwatch.
• Press and hold SET to reset.
NOTE
Unless you stop the stopwatch, "
modes to remind you that the stopwatch is still timing.

USER DATA

To access the full benefits of this product, set up your
user data before you exercise. This will automatically
enable the watch to calculate the level of calories
burned when exercising. This information helps you
track your progress over time.
To set user data:
/
1. Press KCAL to navigate to HR measurement
mode.
2. Press and hold to MODE to enter USER DATA
mode.
3. Press MODE to scroll through the setting options.
The setting sequence is as follows: set Lower
limit; set Upper limit; set Age; set Weight unit; set
Weight.
4. Press SET to increase values.
5. Press MODE to confirm.
NOTE
You must enter your user data to enable the calorie
count function.
To view the amount of calories burnt:
• Press
• Press
NOTE
" will blink in all
3 seconds.

ADDITIONAL INFORMATION

BATTERY

The SE128 uses a CR2032 lithium battery for the
transmitter and a CR2032 for the receiver. Both are
included with the unit. When the receiver battery is
running low, the low battery indicator
on the watch display.
If the heart rate readings become erratic or stop, your
transmitter battery may need replacing.
To change the battery:
1. Open the transmitter battery lid with a coin by turning
it counterclockwise.
2. Insert a new CR2032, 3V lithium battery.
3. Replace the battery compartment door.
NOTE
the battery can discharge. If you are unsure about the
8
/
KCAL to navigate to HR mode.
/
KCAL to view calories burnt.
The calorie display will only appear for approximately
Take care not to touch the two contacts otherwise
will light up