Safety Instructions; Typical Installation; Parts Description; Overview - ITT GOULDS BF15 Manual Del Usuario

SAFETY INSTRUCTIONS

TO AVOID SERIOUS OR FATAL PERSONAL INJURY
OR MAJOR PROPERTY DAMAGE, READ AND
FOLLOW ALL SAFETY INSTRUCTIONS IN MANUAL
AND ON PUMP.
THIS MANUAL IS INTENDED TO ASSIST IN THE
INSTALLATION AND OPERATION OF THIS UNIT
AND MUST BE KEPT WITH THE PUMP.
This is a SAFETY ALERT SYMBOL.
When you see this symbol on the pump, the
controller or in the manual, look for one of
the following signal words and be alert to
the potential for personal injury or property
damage.
Warns of hazards that WILL cause serious
DANGER
personal injury, death or major property
damage.
Warns of hazards that CAN cause serious
WARNING
personal injury, death or major property
damage.
Warns of hazards that CAN cause personal
CAUTION
injury or property damage.
NOTICE: INDICATES SPECIAL INSTRUCTIONS
WHICH AREVERY IMPORTANT AND
MUST BE FOLLOWED.
THOROUGHLY REVIEW ALL INSTRUCTIONS
AND WARNINGS PRIOR TO PERFORMING ANY
WORK ON THIS CONTROLLER.
MAINTAIN ALL SAFETY DECALS.

TYPICAL INSTALLATION

TYPICAL INSTALLATION
17
16

PARTS DESCRIPTION:

1) Pump and Motor
2) Check Valve (built-in
on GS Series
3) Torque Arrestor
4) Pump Power Cable
with Splice Kit
5) Electrical Tape
(Cable to Pipe)
6) Safety Rope
7) Well Cap / Seal
8) Pitless Adapter
9) Controller
2
11
20 9
10
13
4
12
15
19 14
10) Power Supply Cable
11) Service Entrance
12) Pressure Sensor Cable
with drip loop
13) Hydro-Pro Tank
14) Pressure Sensor
15) Pressure Gauge
16) Relief Valve
17) Shut-Off Valve
18) Drop Pipe
19) Lateral Pipe
20) Disconnect
This controller is not designed for use in
WARNING
swimming pools, open bodies of water,
hazardous liquids, or where flammable gases exist.
Disconnect and lockout electrical power
WARNING
before installing or servicing any
electrical equipment.
NOTICE: RECORD THE MODEL NUMBERS AND
SERIAL NUMBERS FROM THE PUMP AND
CONTROLLER ON THE FRONT OF THIS
INSTRUCTION MANUAL FOR FUTURE
REFERENCE. GIVE IT TO THE OWNER OR
AFFIX IT TO THE CONTROLLER WHEN
FINISHED WITH THE INSTALLATION.

1: OVERVIEW

1: OVERVIEW
ELECTROCUTION HAZARD.
WARNING
CONTROLLER, MOTOR, PLUMBING,
AND ALL OTHER METAL NEAR THE
MOTOR CABLE MUST BE
CONNECTED TO THE SERVICE
ENTRANCE GROUND TERMINAL.
All electrical work must be performed by a
WARNING
qualified technician. Always follow the
National Electrical Code (NEC), or the Canadian Electrical
Code, as well as all local, state and provincial codes. Code
questions should be directed to your local electrical
inspector. Failure to follow electrical codes and OSHA
safety standards may result in personal injury or equipment
damage. Failure to follow manufacturer's installation
7
8
18
6
5
4
3
2
1