Manual Operations - Irritrol TOTAL CONTROL Guia Del Usuario

MANUAL OPERATIONS

Manual operation allows you to run individual stations or start automatic
watering programs as needed. The Total Control provides separate dial
positions for each type of operation: Single Station and Program Cycle.
SINGLE STATION
This option enables individual stations to be operated for an untimed
duration (turned On/Off) or operated for a selectable duration from
one minute to 10 hours.
1. Turn the function dial to the
2. Select Program
Note: The programmed status of the master valve/pump start in
the selected program determines whether the master valve/pump
start will be activated with the manual operation.
3. Use one of the following options to operate the station.
For untimed operation:
. Press the
A
wish to operate.
. Press the
B
until one of the following occurs:
•The
•The controller clock passes midnight
•The function dial is moved to another position
For timed operation:
. Press the
A
to operate.
. Use the + and/or – buttons to set the desired amount of station
B
run time (for this operation only), from one minute to 10 hours.
. To select additional stations to operate in sequence, repeat steps
C
and
A
order they were selected.
. Leave the function dial in the
D
manual operation is complete, then return the dial to the
position.
Operating the Controller
16
Single Station
, , or with the
A B C D
button as necessary to display the station you
NEXT
button. The station will turn on and remain on
ON
button is pressed
OFF
button as necessary to display a station you wish
NEXT
as desired. Each station will operate one-by-one in the
B
position.
switch.
Program
position until the
Single Station
Run