Sears Kenmore ELITE 790.4715 Serie Manual Del Usuario página 15

Setting Warmer Drawer Controls
To Set the Warmer Drawer & Bread Proof Controls:
The control and indicator lights for the Warmer Drawer Bread Proof features are
located on the control panel. The temperatures are approximate, and are
designated by HI (high), MED (medium) and LO (low) and BREAD PROOF.
1. Touch the pad at the Warmer Drawer control position. The Warmer
Drawer indicator light will flash. Note: If no further pads are touched within 25
seconds the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch
(see Figure 2) or
Warmer Drawer indicator light located above the ON/OFF pad will turn ON
steady.
3. Each touch of the
power levels from HI (see Figure 2) to MED (see Figure 3) to LO (see Figure 4)
and to the Bread Proof feature (see Figure 5). If the Warmer Drawer is set at
the LO setting and the
indicator light will be set (see Figure 5 and bread dough preparation instructions
on this page). To return to standard Warmer Drawer setting touch
least once. Note: For best results, preheat the Warmer Drawer before adding
the food or bread dough. An empty drawer will preheat in approximately 15
minutes.
4. When the food is ready for removal, touch the
Warmer Drawer or bread Proof feature OFF. The Warmer Drawer indicator light
will turn OFF.
Preparing Bread Dough for the Warmer Drawer
The Warmer Drawer has a Proof Bread feature that can be used to
help prepare bread dough. The recommended length of time to keep
bread dough in the Warmer Drawer is about 45-60 minutes. Be sure
however to follow the recipe's recommended times.
The unrisen bread dough should be placed in a large bowl since the
dough will nearly double in volume. Before placing in the Warmer
Drawer, cover the bowl with a moist cloth or use wax paper that has
been coated with a non-stick type cooking spray (see Figure 6).
Place the bowl in the Warmer Drawer and follow the Warmer Drawer
and Bread Proof Control setting instructions at the top of this page.
Note: The Warmer Drawer is inoperable during the self-clean
cycle.
once to turn ON the power level for HI
to turn ON the power level for LO (see Figure 4). The
or pads will decrease or increase through 6
pad is touch again the Bread Proof feature and
pad at
pad once to turn the
15
Figure 1
Figure 2 Figure 3
Figure 4
Figure 5
Figure 6